Posts by KEFAN Robotics Editorial Team
Automated Injection Molding: A Practical Planning Guide
Plan automated injection molding around the part, mold, machine, robot task, EOAT, interface, safety, and downstream process with this practical buyer guide.
Injection Molding Automation Case Study: Scaling a Household Appliance Production Line
An anonymous household-appliance manufacturing case study showing how KEFAN linear robots, conveyors, and injection molding machines can be organized into a scalable production line.
When to Choose Custom Automation After Injection Molding
When to Choose Custom Automation After Injection Molding
Injection molding often starts with one clear task: remove the molded part fro...
EUROMAP 67 for Injection Molding Robots: Buyer Guide
EUROMAP 67 is a common reference when a buyer connects an injection molding machine with a handling device or robot. It helps the proje...
Injection Molding Robot Cycle Time: How to Reduce Take-Out Time
Injection molding robot cycle time should be evaluated as part of the complete molding sequence. Robot travel is only one element. Mold...
How to Design EOAT for an Injection Molding Robot
Injection molding robot EOAT design determines how reliably a part is picked, protected and released. A robot can have enough movement ...
How to Select an Injection Molding Robot by Machine Tonnage
When buyers ask how to select an injection molding robot by machine tonnage, machine tonnage is a useful starting point. It helps narro...
How to Choose an Injection Molding Robot: Complete Selection Guide
When buyers ask how to choose an injection molding robot, the decision should start with the complete application rather than one machi...
3-Axis vs. 5-Axis Injection Molding Robots: Which One Fits Your Application?
A 3-axis vs 5-axis injection molding robot comparison should start with the required motion after the part leaves the mold. A 3-axis ro...
How Much Does an Injection Molding Robot Cost?
Injection molding robot cost depends on the robot architecture, strokes, payload, end-of-arm tooling and the work required after part r...